Replies to This Discussion

Permalink Reply by VU - Founder - Zurek on September 8, 2009 at 7:01am

Source Connect Standard is good enough to start with. It does what it is supposed to do... connect you to the opposing Source Connect.

• ▶ Reply

Permalink Reply by Alexis Serrano on September 9, 2009 at 12:15am

Thanks Zurek, I will tell my Dad to get it.

• ▶ Reply

Permalink Reply by Pablo Hernandez-Pagan on April 26, 2010 at 2:27pm

How much does Source-Connect cost?

• ▶ Reply

Permalink Reply by Alexis Serrano on April 26, 2010 at 2:39pm

$650

http://sourceelements.com/purchase/

It does not work with a Pro Fire Interface we found that out the hard way, The Mackie mixers were recommended by George and it works fine.
Alexis

• ▶ Reply

Permalink Reply by Pablo Hernandez-Pagan on April 26, 2010 at 2:44pm

Thanks so much, Alexis!

• ▶ Reply

Permalink Reply by John Munoz on May 5, 2010 at 9:51am

Hi Alex, a quick question have u used source connect on a ISDN bridging session?...just wondering If is stable or not

• ▶ Reply

Permalink Reply by John Munoz on May 5, 2010 at 9:51am

Hi Alex, a quick question have u used source connect on a ISDN bridging session?...just wondering If is stable or not

• ▶ Reply

Permalink Reply by Alexis Serrano on May 5, 2010 at 8:34pm

We have not done it yet, my dad spoke to someone from "out of hear" a bridging service in Los Angeles, who said he would be happy to run a test for us. He told my dad works fine. http://www.outofhear.com/


We have not yet had a client who requested it though.

• ▶ Reply